EMFIMOUSSE PISTOLÉTABLE is an aerosol, moisture curing one-part polyurethane foam.
EMFIMOUSSE PISTOLÉTABLE has a good adhesion on most popular building materials : concrete, brick, plaster, PVC, metal, wooden materials, polyurethane foam.


EMFIMOUSSE PISTOLÉTABLE is used for mounting and sealing windows and doorframes, and for filling and sealing all joints.
Also used for sound-proofing (dividing walls, car and boat cabins...), insulation work (water-pipes...), bonding roof tiles.


Substrates preparation :
The substrates must be clean, without any traces of grease or other contaminants that could adversely affect the bonding performance.
Wet porous substrates before foam application.
Application :
Shake the can strongly about 20 times with the valve down before use.
Screw the adapter onto the nozzle. Press lightly on the trigger, always with the valve down. Screw it on the gun and press on the trigger (ca. 2 s) in order to fill the gun with foam.
The can must always have the valve down during extrusion. An adjusting screw at the rear of the can allows to regulate the wanted quantity of foam.
In case of change of can, shake strongly the new one and replace it without waiting. Otherwise, the foam could harden inside the adapter.
Do not fill the holes because the foam expands during setting between 30 and 80 %.
Fill gradually the holes wider than 5 cm, waiting hardening between every layer.
When mounting door and window frames, mechanical connectors and struts should be used.
After full cure, cut if necessary the excess with a knife and protect against UV radiation by covering with sealant mass, plaster or paint.
Cleaning :
After application and if the bottle is not empty or when a break in application lasts more than 15 min, clean the nozzle and the flexible pipe with EMFINET MOUSSE PU.
This solvent also allows to clean the smudges during working (substrates, clothes).
EMFINET MOUSSE PU must be used immediately because it has no effect after curing.
Cured foam can be removed only mechanically.